|
I only plan on doing mild performance mods to the car. But first, I have some things that I need to get done to make the car more reliable and safe.
Here is what I am looking at doing.
-
Install new clutch, flywheel, adjustable cable, billet quadrant, firewall adjuster, and short throw shifter. Also replaced the rear main seal. (Completed 14 Sep 2010)
-
Turn rear drums, replace shoes...this should also fix the parking brake. (Completed 5 Sep 2010)
-
Replace front rotors, install new pads, clean and repack wheel bearings. (Completed 12 Sep 2010
-
Replace inner and outer tie rods, lower ball joints and get front end alignment. (Completed 14 Sep 2010)
-
New wheels and tires. (Completed 5 Mar 2011)
-
65mm throttle body and spacer.
-
Cold air intake.
-
1 5/8 inch shorty headers. (unequal)
-
2 1/2 inch high flow x-pipe.
-
211/42 inch cat back exhaust.
-
MSD ignition system.
-
24 lb injectors.
-
73mm mass air meter.
-
3.55 rear gears. (Car already has installed)
-
Aluminum drive shaft.
-
9mm spark plug wires.
-
Replace A/C compressor, recharge.
-
Replace struts, shocks, and quad shocks...alignment. (Completed 4 Mar 2011)
-
Caster/Camber plates. (Completed 4 Mar 2011)
-
Upper and lower intake. (Cobra or Trick Flow)
-
Tune.
|
Engine/Drivetrain/Brakes/AC
